BOM

Bill of material for one node

NOTE: For a complete BOM needed to setup one node with five sensors including the LoRaWan gateway checkout this link. (link til teams)

Parts for one node:

Name	QTY	Link
Main board:
CubeCell - Dev-Board (V2)	1	Heltec
TCA9548A I2C Multiplexer	1	ADAFRUIT
Adafruit Perma-Proto Half-sized Breadboard PCB	1	ADAFRUIT
Slide Switch	1	RS COMPONENTS
Screw terminal	1	RS COMPONENTS
BD679 - transistor	1	ELFA DISTRELECT
Resistor 10kohm	1	ELFA DISTRELECT
MAIN_BOARD_HOLDER	1	Link at the bottom
ADC board:
ADS1115 16-Bit ADC	1	ADAFRUIT
Adafruit Perma-Proto Quarter-sized Breadboard PCB	1	ADAFRUIT
ADC_BOARD_HOLDER	1	Link at the bottom
Battery pack:
RE520-HP, Single-Sided Stripboard	1	RS COMPONENTS
Litium-ion-batteri 3.6V 2600m	2	ELFA DISTRELECT
Battery Holder 2 x 18650 Through Hole, Keystone	1	ELFA DISTRELECT
Main box:
CLWIB 2 - box	1	ELFA DISTRELECT
SWITCH/terminal block	1
0.5W Solar Panel 55x70	2	ELFA DISTRELECT
TE Circular Connector, 4 Contacts, Panel Mount Female	4	RS COMPONENTS
M5 Nuts	1	ELFA DISTRELECT
M5_NUT_HOLDER	4	Link at the bottom
INNER_RAIL	2	Link at the bottom
Screw terminal	1	RS COMPONENTS
Slide switch	1	RS COMPONENTS
Various materials used for building:
HellermannTyton, 3:1 Ratio, ShrinKit 321 Basic Series	1	RS COMPONENTS
Assorted wire 7.6m, SparkFun Electronics	1	ELFA DISTRELECT
Epoxy glue (can be different glue)	1	RS COMPONENTS

3D-printed parts:

The 3D-printed parts you need for each node can be found in the 3D-printing section.

Node parts3D-printing list for one node.