BH1750 (i2c)

This page explains how to create and setup the BH1750 Light sensor.

How to prepare the BH1750.

The only thing you need to do for the BH1750 sensor is to attach it to its case.

1. Place the sensor into its 3D-printed case.

2. 

   Sensor inside the case.
3. Glue the case on the lid of the box. The case should be glued on the clear part of the lid towards the right side.

4. 

   Top view of box with sensors.

   

   Inside view of lid with sensors.
5. The next step is to soldering the I2C STEMMA Cable wires onto the main board. (Go to final assembly, below).

Final assemblyThis page explains the final assembly of the node